Installation guide

Installing the BlackDiamond 20808 Chassis
BlackDiamond 20808 Switch Hardware Installation Guide
56
To ground the chassis:
1 Locate the grounding point on the back of the chassis (Figure 23).
Figure 23: Back of BlackDiamond 20808 Chassis
2 Strip 0.5 inch (1.2 cm) of insulation from the copper wire cable.
3 Insert the stripped wire into the cable lug.
4 Crimp the lug onto the cable according to the manufacturer’s specifications.
5 Insert the screws through the lug and into the grounding point on the back of the chassis. Tighten
the screws securely.
6 Connect the other end of the wire to a known reliable earth ground point at your site.
Chassis grounding point