Installation guide

Installing a 2400 W AC Power Supply Unit (PSU)
BlackDiamond 20808 Switch Hardware Installation Guide
61
Figure 28: Connecting Power with a Wire-Style Power Cord Retainer
4 Connect the other end of the power cord to a grounded AC power outlet.
Leave the ESD strap permanently connected to the switch, so that the strap is always available when
you need to handle ESD-sensitive components.
Using the Clamp-Style Power Cord Retainer
1 Attach the power cord retainer to each installed PSU as follows (see Figure 29):
a Loosen the two screws on the AC input connector housing on the PSU.
b Slide the power cord retainer down and between the loosened screw-heads and the AC input
socket as shown in Figure 29.
c Tighten the screws to secure the power cord retainer.
1
BD_175
2 3