Installation guide

Installing Power Supplies in the BlackDiamond 20808 Switch

BlackDiamond 20808 Switch Hardware Installation Guide

Figure 29: Connecting Power with the Clamp-Style Power Connector Retainer

2 Connect the AC power cord to the PSU as follows:

a Loosen the middle screw of the power cord retainer to allow the power cord connector to slide

through it.

b Connect the power cord connector to the AC input on the front of the PSU (see Figure 294).

c After the power cord is connected, tighten the middle screw of the power cord retainer to secure

the power cord in place.

3 Connect the other end of the power cord to a grounded AC power outlet.

Leave the ESD strap permanently connected to the switch, so that the strap is always available when

you need to handle ESD-sensitive components.

BD_175