Installation guide

Installing Management Modules and I/O Modules
BlackDiamond 20808 Switch Hardware Installation Guide
75
4 Remove the module from the anti-static packaging as follows:
a Place the ESD bag containing the module on a flat ESD surface that is clear of any debris.
b Break the quality seal, the ESD warning seal, and the Read Installation Note seal.
c Open the ESD bag and carefully remove the module.
CAUTION
To prevent ESD damage, hold the module by the front panel only. Never touch the components on the PCB or
the pins on any of the connectors.
5 Align the module with the card guides in the chassis, and keep the injector/ejector levers in the
open position as you carefully slide the module partway into the chassis slot (see Figure 42).
6 Verify that the module injector/ejector levers are open (Figure 42).
Figure 42: Installing a Module (Management Module Shown)
CAUTION
Do not slide the module all the way into the chassis slot if the injector/ejector levers are in the latched position.
7 When the module makes contact with the chassis backplane, simultaneously rotate both levers
toward the center of the module to fully seat the module in the slot (Figure 43).
BD_185