Installation guide

Installing the BlackDiamond 20808 Modules
BlackDiamond 20808 Switch Hardware Installation Guide
82
4 Remove the module from the anti-static packaging as follows:
a Place the ESD bag containing the module on a flat ESD surface that is clear of any debris.
b Break the quality seal, the ESD warning seal, and the Read Installation Note seal.
c Open the ESD bag and carefully remove the module.
CAUTION
To prevent ESD damage, hold the module by the front panel only. Never touch the components on the PCB or
the pins on any of the connectors.
5 Verify that the module injector/ejector levers are open (Figure 50).
6 Align the module with the card guides in the chassis, and keep the injector/ejector levers in the
open position as you carefully slide the module into the chassis slot (Figure 50).
CAUTION
Do not slide the module all the way into the chassis slot if the injector/ejector levers are in the latched position.
7 When the module makes contact with the backplane, simultaneously rotate both levers toward the
center of the module to fully seat the module in the slot (Figure 50).
Figure 50: Installing a Switch Fabric Module
8 Using a # 2 Phillips screwdriver, align and tighten the captive retaining screws (Figure 51).
When you install multiple XFM-1 modules, always secure each installed module before you insert
the next adjacent module.
BD_191