Installation guide

Packing the BlackDiamond 20808 Chassis for Shipping
BlackDiamond 20808 Switch Hardware Installation Guide
90
c Rotate the open side of the baffle away from the side of the chassis and slip the back edge tabs
out of the side air intake grill.
Figure 55: Removing an Air Baffle
3 If necessary, attach the 19-inch support bracket to the equipment rack immediately below the chassis.
4 Remove the chassis from the rack:
a Remove the rack mounting screws that secure the chassis to the rack.
b Carefully slide the chassis out of the rack and set it on the pallet, nested in the lower packing
foam.
Assembling the Shipping Container
To assemble the packaging around the chassis:
1 Slide the box down over the chassis and onto the pallet.
2 Set the upper packing foam in place on top of the chassis in the box.
3 Package the air baffles and set them on top of the chassis between the pieces of the upper packing
foam.
4 Close the top flaps on the shipping box and seal them with packing tap
5 Use package strapping to secure the upper box to the pallet.
BD_201