Installation guide

Cable Management Accessories
BlackDiamond 20808 Switch Hardware Installation Guide
96
8 Set the bottom edge of the cover on the hinge tabs of the cable manager base (see Figure 61). Rotate
the cover into place and press firmly at the top until the latches lock.
Figure 61: Cable Manager Cover Plate
Using the Cable Holders and Cable Clips
When you use the cable holders and the cable clips, Extreme Networks recommends the following:
● Attach the cables to the holders by slipping the cable through the opening.
● Connect the cable holders, if you need more than one. (Refer to “Connecting Cable Holders” on
page 97.)
● If you need more than one cable clip for a bundle, connect the clips together before you route the
cables through the clips. (Refer to “Connecting Cable Clips” on page 98.)
● To form a cable bundle, thread the cables through the clips.
Figure 62 shows the cable holders and clips being used to manage a group of cables.
EX_078
Latches at top of closed cover
Top view of open/removed cover
Hinge tabs fit into cable manager base