Product Brochure

ManualsBrandsBlackburn ManualsElectricalCopper Lay-In Lug Connector for #4 to #14 Wire (Case of 10)

20 BLACKBURN GROUNDING SYSTEMS

—

General usage instructions

Separate

No special tools required. Use ordinary parallel jaw

pliers to separate the connector into two parts.

Hold one side of connector with pliers and bend

opposite side back and forth until parts separate

(see Fig. 1).

Caution: Be careful not to pinch fingers or thumb when separating parts.

Keep fingers out of bend path when bending part against plier jaws.

Installation

1. Strip the insulation from each de-energized

conductor. Be careful not to nick the conductor.

Clean the conductor ends with a wire brush or

emery cloth if necessary.

2. Place each conductor into the grooves in body

piece. Press conductors with pliers to align

and seat into grooves (see Fig. 2).

3. Hold the conductors and body piece until it

stops. Use parallel jaw pliers and grip the snap

and body pieces as shown (see Fig. 3). Apply

pressure until connector “snaps” into place.

Visually inspect snap to verify full insertion.

The connection is now complete (see Fig. 4).

Removal

The connector can be disassembled using a

flat-head screwdriver to pry the snap piece

from body piece.

—

Bend back and

forth to separate

Separation point

Body piece

Install

—

Snap piece

Pivot groove

Body piece

—

E-Z-Ground

™

grounding connectors

SnapTap

™

connector (continued)

—

01 Fig. 1

—

02 Fig. 2

—

03 Fig. 3

—

04 Fig. 4