Instructions / Assembly

STEP 
Make sure LP tank is
properly connected to unit. Turn
gas ON at LP cylinder by taking 20
seconds to turn knob halfway.
! WARNING
Do not lean over griddle
while lighting.
! WARNING
If ignition does NOT
occur in 5 seconds, turn
burner controls OFF, wait
5 minutes and repeat
lighting procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner
and could accidentally/
inadvertently ignite with
risk of injury.
IGNITION |
PIEZOELECTRIC
If ignition does NOT occur in 5 seconds, turn burner control OFF, wait 5
minutes and repeat lighting procedure.
For additional support, see youtube.com/blackstonegriddles
GRIDDLE OPERATING INSTRUCTIONS
For proper ignition and operation of the griddle follow the steps below.
STEP 
Adjust temperature to
desired level.
STEP 
Push in control knob to
start gas owing, then turn control
knob counter-clockwise to acti-
vate starter.
Ignition | Piezo-Electric
TROUBLESHOOTING
SYMPTOMS
01. Burner will not ignite with piezo ignition system
If ignition does not occur in 5 seconds, turn the burner controls o, wait 5
minutes and repeat the lighting procedure. If this does not work, to deter-
mine the cause, please try to ignite your griddle with a match. (Please
reference the Match Lighting Instructions in the Cleaning the Burner
Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
01. Igniter wire misaligned. Ensure that the igniter wire is posi-
tioned 1/8” to 1/4” away from the burner
tube, positioned above a burner hole.
02. Damage to the ignition system. Contact customer service for replace-
ment parts.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
03. Burner tubes are not
receiving propane.
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Section 01
PIEZOELECTRIC IGNITION
TROUBLESHOOTING
TroubleshootingModel 1814 | Owner’s Manual | | Owner’s Manual | Model 1814
22 23