Owner manual

8
Installing the BlackVue in a vehicle
1.
Stop the engine and remove the key
from the ignition.
N
Install the BlackVue in a well-lit and safe
location.
2.
Insert a Micro SD card into the BlackVue.
N
For more information on using the
Micro SD card, refer to page 7.
3.
Attach the BlackVue to a windshield of
your car using double-sided tape.
N
We recommend that you install the
BlackVue behind the rear view mirror.
The lens of BlackVue should be located
on the center of the vehicle.
N
Install it in a location that does not
hinder your visibility.
N
Wipe all foreign material and moisture
from the surface to which the double-
sided tape will be attached using a soft
and dry cloth.
N
If the product is installed on a window
hot wire, this may cause the hot wire
to be damaged when removing the
product later.
N
If the BlackVue happens to be removed
from the holder, refer to page 10.
4.
Connect the [DC IN] terminal of the
BlackVue and the cigarette jack of
your car using the power cable.
N
For parking mode, connecting the
POWER MAGIC (a battery power
controller) is recommended.
N
Use a multi power leads, in case
BlackVue is used with other car device.
Using the BlackVue
Installing the BlackVue
d
d
d
d