Service manual

XTR Electric Powerboard
Service Manual
www.tanaka-usa.com [e-mail]
Revison 002
12
Steering Head Components / Suspension Fork Model
Figure 15 Figure 16
Next, remove the three pinch bolts that attach the upper and triple clamp supports to the fork tubes and the
steering head, (fig. 15), followed by removal of the bearing adjustment nut, (fig.16).
With these components removed, the fork unit can be removed from the steering head through the bottom.
Note: If it is not necessary to service the brake or wheel components, they can remain attached to the lower
triple clamp support and fork tubes, while servicing the steering head components.
Take the opportunity to thoroughly clean all parts with cleaning solvent, and inspect bearings. If they feel
worn or do not turn freely, replace them. Re-grease the bearings and carefully re-assemble.