Service manual

XTR Electric Powerboard
Service Manual
www.tanaka-usa.com [e-mail]
Revison 002
14
Deck Removal
Figure 20
The XTR deck is secured to the frame with 10 bolts, (standard wood version – aluminium billet decks have less
fasteners), requiring a 4mm hex wrench and a 10mm open-end wrench. Some of these bolts are secured on
the bottom side with locking nuts, and some of the bolts are simply threaded into the frame itself. For those
bolts secured with nuts on the underside, remove the nuts prior to attempting to remove the bolts from the
top.
Additionally, some of the mounting bolts may be covered by grip tape, and access to them will require the
removal of the grip tape.
Inspect the board for any damage and replace as necessary. When re-installing a deck, always ensure that all
fasteners are used, and that an adequate amount of grip tape is re-applied to ensure sound footing when in
operation.