SDS

PB Penetrating Catalyst
Safety Data Sheet
according to the Hazard Communication Standard (CFR29 1910.1200) HazCom 2012
9/24/2019
EN (English)
3/7
Precautions for safe handling
7.1.
SECTION 7: Handling and storage
6.4. Reference to other sections
Emergency procedures
:
Ventilate area.
Prevent entry to sewers and public waters. Notify authorities if liquid enters sewers or public waters.
For containment : Eliminate sources of ignition. Contain and/or absorb spill with inert material (e.g. sand,
vermiculite), then place in a suitable container. Do not flush to sewer or allow to enter
waterways. Use appropriate Personal Protective Equipment (PPE).
Methods for cleaning up : Scoop up material and place in a disposal container. Provide ventilation.
See section 8 for further information on protective clothing and equipment and section 13 for advice on waste disposal.
Precautions for safe handling : Do not spray on an open flame or other ignition source. Keep away from sources of ignition -
No smoking. Use non-sparking tools. Use explosion-proof equipment. Take precautionary
measures against static discharge. Avoid contact with skin and eyes. Do not swallow. Do not
breathe gas, fumes, vapour or spray. When using do not eat, drink or smoke. Use only
outdoors or in a well-ventilated area. Do not pierce or burn, even after use.
Hygiene measures : Launder contaminated clothing before reuse. Wash hands before eating, drinking, or smoking.
Technical measures : Proper grounding procedures to avoid static electricity should befollowed.
Storage conditions : Keep locked up and out of reach of children. Do not expose to temperatures exceeding 50 °C/
122 °F. Store away from direct sunlight or other heat sources. Keep in fireproof place.
Storage area : Store in a well-ventilated place.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Petroleum distillates, hydrotreated light (64742-47-8)
Not applicable
Solvent naphtha, petroleum, heavy aromatic (64742-94-5)
Not applicable
Distillates, petroleum, hydrotreated heavy naphthenic (64742-52-5)
Not applicable
Carbon dioxide (124-38-9)
ACGIH
ACGIH TWA (ppm)
5000 ppm
ACGIH
ACGIH STEL (ppm)
30000 ppm
OSHA
OSHA PEL (TWA) (mg/m³)
9000 mg/m³
OSHA
OSHA PEL (TWA) (ppm)
5000 ppm
Appropriate engineering controls : Use ventilation adequate to keep exposures (airborne levels of dust, fume, vapor, etc.) below
recommended exposure limits.
Hand protection : Wear chemically resistant protective gloves.
Eye protection : Safety glasses or goggles are recommended when using product.
Skin and body protection : Wear suitable protectiveclothing.
Respiratory protection : In case of insufficient ventilation, wear suitable respiratory equipment. Respirator selection
must be based on known or anticipated exposure levels, the hazards of the product and the
safe working limits of the selected respirator.
Environmental exposure controls : Maintain levels below Community environmental protection thresholds.
Other information : Do not eat, smoke or drink where material is handled, processed or stored. Wash hands
carefully before eating or smoking. Handle according to established industrial hygiene and
safety practices.
6.2. Environmental precautions
6.3. Methods and material for containment and cleaning up
7.2. Conditions for safe storage, including anyincompatibilities
8.2. Exposure controls