Instruction manual

AIR FILTER CLEANING

Loosen the sleeve screw, no.2 (see Fig. 3) so you can remove the air filter cover,

no.1. Now you have free acces to the filter. Remove the filter, clean it in petrol and

lubricate it with engine oil. To re-install the filter, reverse the procedure above.

PINION REPLACEMENT (Fig. 5)

First, dismantle the chain guard. Then

loosen the rear axle eccentric bolts and

the rear brake reaction catcher. Remove

the drive chain. Insert, carefully, a large

screwdriver or steel rod into the clutch

drum hole, to avoid the clutch drum

turning when releasing the pinion (Fig. 5).

Use a special pinion wrench (319.050.00)

to replace the pinion.

FRONT AXLE ALIGNMENT

Front axle alignment is performed by adjusting the steering tie rod length. Loosen the

nuts (M8) and dismantle the steering joint at both front wheels. Loosen the steering

tie rod safety nut (M8) and by screwing the tie rod end in or out, adjust the

length accordingly. The toe-in angle of the front wheels should be between 0°

and 1°.

STORAGE PROCEDURE

If the vehicle is to be left unused for a period of time, it is recommended to drain out

all the fuel from the fuel tank and carburetor. Inflate the tyres to the normal working

pressure. Remove the spark plug, clean it, put a few drops of motor oil into the

cylinder, pull the starter rope 2-3 times, so an oil film evenly coats the cylinder walls

and piston. Re-install the spark plug.