Instruction manual

UNPACKING AND SETTING UP BEFORE RIDING

Your Quadard is packed with folded handlebars and brake lever. After unpacking,

set up the handlebars to a comfortable position. After setting-up the handlebars,

tighten the handlebar bolts (M6), the brake lever bolt, and the throttle grip bolt

according to Fig.1. While tightening the bolts, do not use an excessive force.

Overtightening the bolts may cause damage of the threads or other parts. Verify the

smooth and free movement of both control cables (throttle and brake).

Fig. 1

Controls :

1. Handlebar bolts

2. Brake lever bolt

3. Throttle grip screw

4. Engine stop switch

5. Rear brake lever

BEFORE STARTING THE ENGINE

Engine and performance : It is important for the vehicle to be properly run in. The

engine is considered properly run in after consuming five fuel tanks full of mixed

petrol. During the running in period use a 30 : 1 pre mix 2-stroke synthetic oil.

(166 millilitres of oil to 5 litres of petrol )

Once the engine is run in ( Five fuel tanks full ) you can then change the mixture to

50:1 ratio.

(100 millilitres of oil to 5 litres of petrol )

Always mix your oil and petrol in a seperate container making sure it is mixed

properly before filling the fuel tank.

During the running in period, do not use full throttle and do not allow the engine to

overheat, otherwise you will damage your engine.

Check the tyre pressure which should not exceed 2,5 bar

Always inspect the bike before each ride (refer to the article ‘INSPECTION

AND MAINTENANCE’

). Failure to inspect and maintain your Quadard

properly increases the risk of an accident or damage to the vehicle.