Instruction manual

DRIVE CHAIN ADJUSTMENT

Loosen the bolts (M5) on the rear axle carrier also loosen (M6) bolt on the rear

brake to allow for tensioning the chain, then adjust by moving the excentric disc on

the axle, the drive chain slack should be 5 mm (0,2 in). making sure not to over

tighten the chain. fasten the (M5) bolts on the axle carrier remembering to tighten the

M6 bolt on the brake.

It is important to lubricate the chain regularly, to avoid excess wear. This will prolong

the lifetime of the chain. it is important to lubricate the chain after every ride and

especially in wet conditions. It is recommended to use a quality chain lubricant. If the

chain needs replacement, then please also check the front and rear sprockets for

wear, replace accordingly.

Riding with a chain in poor condition or improperly adjusted can lead to

serious injury. Always, Inspect, Adjust and Maintain the drive chain

properly before each ride.

CENTRIFUGAL CLUTCH SHOES REPLACEMENT

Remove the chain guard by loosening two bolts (M6). Release the chain and

dismantle it. Loosen the four bolts (M6) holding the cover of the clutch. Release the

engine brace on the frame, and move to one side, remove the whole cover together

with the clutch drum. Use a pair of pliers to draw off the clutch springs and loosen

the pins holding the clutch shoes. Install new clutch shoes and springs (if required).

To re-install the clutch assembly, reverse the sequence as described, and then re

adjust the tension of the drive chain.

REAR BRAKE ADJUSTMENT (Fig. 4)

General adjustment:

The general brake adjustment can be made

by turning the adjusting screw on the brake

lever on the handlebars.

Basic brake adjustment:

Screw in the adjusting screw at the brake

lever. Loosen the nut (no. 3), and tighten the

adjusting bolt (no. 4), so the wheel cannot

turn. Back off the bolt (no. 4) about ¼ to ½ of

a turn and fix it with the lock nut (no.3).

Do not adjust the cable retainer (no. 5) for

adjusting the brakes!

Failure to inspect and properly maintain the brake increases the risk of

having an accident. Before each ride check the rear brake cable and the

brake efficiency.