Operation Manual

CLR 40
SETTING TIME AND DATE
1. Press & hold SET button for around 2 seconds until the display flash and
entered the year setting.
2. Press SCAN+ or SCAN- until the correct year appears in the display.
3. Press SET to confirm
4. Repeat steps 2 and 3 to set the month, day and time.
Notes: After setting the minute the clock starts from 0 seconds. But if you do
not set "Minute", the clock does not start from 0 second
RADIO OPERATION
1. Press the MODE button to turn to radio mode.
2. Adjust the volume using VOL+ or VOL-
3. Use SCAN+ or SCAN- to tune into the desired station. Press and hold the
button for auto forward or backward radio station searching
4. To turn off the radio, press MODE button for around 2 seconds.
Notes: For the best FM reception, extend the FM wire antenna to its full
length and vary the direction to capture the strongest signal. Do not
connect the FM wire antenna to an outdoor antenna.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 radio stations in FM could be preset.
1. Follow steps in "Operating the Radio" and manually tune into the station
that you wish to preset.
2. Press and hold MEMO button for around 2 seconds, the "MEM" icon is
flashing on display then press the MEMO button again for registration (User
can also press SCAN+ or SCAN– to set the preset station number). After the
preset has finished, the preset number will appear on the display.
3. To preset another station, repeat these steps.
4. To change the preset station, tune into the desired station and press the
MEMO button for around 2 seconds, the "MEM" icon is flashing then press
SCAN+ or SCAN– to select the preset radio number user want to replace.
Press the MEMO button again for registration, the new station will replace
the previous station
5. To hear the preset radio station, press the CH+ button once for the next
preset stations in cycle.
28