Operating instructions Toronto RDM 126 US 1 Toronto RDM126 us-gb 1 22.03.
DEUTSCH 17 FRANÇAIS 16 15 ITALIANO 20 19 18 1 NEDERLANDS 14 3 4 5 6 7 8 9 10 11 12 PORTUGUÊS ESPAÑOL 2 SVENSKA 13 3 Toronto RDM126 us-gb® 3 24.04.
Contents FCC warning for USA ............................. 4 Key Features: ......................................... 5 Codem IV-US Tuner Features: ............... 5 Audio Features: ...................................... 5 CD Player & DMS CD Changer Control Feature Highlights: ................................. 5 Other Features: ....................................... 5 Quick reference .............................. 5 Important notes ............................ 11 Precautions ...............................
DEUTSCH ENGLISH 17 FRANÇAIS 16 15 ITALIANO 20 19 18 1 NEDERLANDS 14 3 4 5 6 7 8 9 10 11 12 PORTUGUÊS ESPAÑOL 2 SVENSKA 13 3 Toronto RDM126 us-gb® 3 24.04.
FCC warning for USA The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications.
Codem IV-US Tuner Features: RDS (Radio Data System) Reception Station Call Letter Display PTY Program Type Seek AF Alternative Frequency Search Emergency Alert System Capability Multipath Management 18 FM/6 AM Presets, including 6 FM/6 AM TravelStore Presets Station Scan & Preset Scan 3 lo and 3 dx Tuning Sensitivities ASU Electrical Impulse Noise Suppression Controls Blaupunkt CDC-A05 or CDCA071 Changer Disc Naming Track program memory Switching on/off with the KeyCard: The set has to be turned on via the
Switching on with the ignition being switched off: To keep on operating the set when the ignition is switched off (KeyCard is inserted), proceed as follows: Press ON after the double beep tone. The unit will be turned on. To avoid that the battery goes flat, the system will be turned off automatically after a playback time of one hour. To program the mute volume level, proceed as follows: • Adjust the desired volume. for two seconds until you • Press hear a beep.
DEUTSCH 7 Display Changer operation (optional) Fast advance, audible (CUE). Hold down as long as required. Track selection Fast reverse, audible (REVIEW). Hold down as long as required. b l m Up Down n ITALIANO CD Disc selection c Upwards: Press briefly. CUE - fast advance (audible): Keep depressed. Downwards: Press as many times as required. To restart a track: Press briefly. REVIEW - fast reverse (audible): Keep depressed.
m) TPM n) T5 - To select and store CD tracks - Track no. 5 is played back 8 KeyCard theft protection system To operate the set it is necessary that the KeyCard is inserted. For this purpose, introduce the KeyCard (with the contact area showing up) into the slot above the tongue sticking out of the unit. To remove the card, press first to unlock. Read also the information in chapter “KeyCard theft protection system”.
To switch between the name and time (playback time) display modes: Press DIS briefly. Changer operation (optional) To switch the display mode and select between name, time (playback time) and number (disc number): • Press DIS briefly. DEUTSCH ENGLISH CD and CDC operation (optional) To clear CD tracks from the TPM memory. ; TPM (Track Program Memory) To select and store tracks during CD/ CDC playback. In each operating mode it is possible to manage a maximum of 30 discs.
To recall a station: Select the desired waveband. On FM, adjust the corresponding memory bank and press the relevant preset button briefly. Extra function preset buttons To store and recall a PTY program type. On FM, you can store and recall one program type on/from each preset button when PTY is active (“PTY” lights up in the display). A CD slot When inserting a disc with the label side facing up, it will be pulled in automatically and transported to the playback position.
Traffic safety As the driver of a motor vehicle, it is your responsibility to pay attention to the traffic situation at all times. Never use your car radio in a way that could distract you. Please keep in mind that you travel a distance of 15 yards per second at a speed of only 30 miles per hour. Should the traffic situation become particularly demanding, we advise you not to use the radio.
KeyCard theft protection system Remote control With the infrared steering wheel remote control and its signal-receiving apparatus you can control all of the important functions of your car audio system from the steering wheel. The Blaupunkt KeyCard Security System provides an effective and convenient means of theft deterrence. Each unit operates only when it’s own card is inserted. No card, no use. It’s that simple.
3. Press << or >>. The display will switch to “CHANGE”. 4. Push in the KeyCard. The card is released and put in the proper position for being removed. 5. Remove the first KeyCard and insert the new one while “CHANGE” is still being displayed. After the display indication “READY” or “LEARN KC”, 6. press DSC. Now you can also use the new KeyCard for operating your unit. A maximum of two cards can be used for the set.
Switching the audio source Radio operation with RDS (Radio Data System) Using the SRC button you can switch between the following audio sources: radio, CD, or CDC (AUX) CD operation is only available if a CD is inserted. AUX is only available if no Blaupunkt changer CDC A05 or CDC A 071 is connected. “AUX ON” must be activated in the DSC menu. To switch to another source, • press SRC briefly. This radio is equipped to receive Radio Data System or RDS signals.
Seek tuning Up Down Down in short intervals (“AF” must be switched off) Up in short intervals (“AF” must be switched off) Manual tuning with << >> RDS Seek (only FM) You can use the << >> buttons to tune in RDS stations. For this it is necessary that the stations have been tuned in at least once and that “AF” is active (lights up in the display). A quick way to tune in RDS stations is to use Travelstore: • Press FMT for two seconds; the system starts to run through the frequency band.
Automatically storing the strongest stations with Travelstore You can automatically store the six most powerful FM and AM stations of your current reception area sorted according to their signal strength. This function is particularly convenient on longer trips. • Press the FMT or AMT button for two seconds. “T-STORE” will appear in the display. The six strongest FM or AM stations will be automatically stored on the memory bank “T” (Travelstore).
Switching PTY on/off • Press PTY. When the function is active, the program type selected last will briefly appear in the display. “PTY” will be permanently indicated in the lower right corner of the display panel. Displaying the selected program type • Press << or >>. The program type selected last will be displayed briefly. Selecting a program type a) Using the preset buttons When PTY is switched on, you can use the preset buttons 1-6 to select the program types stored at the factory.
If you wish to listen to a station with this PTY, • press / to start seek tuning operation. If the system is unable to find a station offering the selected program type, the display will show “NO PTY” and a beep tone will be released. The station received before starting seek tuning will be tuned in. You can assign different program types to each preset position. Please refer to the next chapter “Storing program types”.
Make sure that a disc is inserted, “CD IN” shows on the display panel. Press SRC to go through the available audio sources: • Press as many times until the display briefly shows “CD”. Inserting a CD Track selection Up Down Press once to go back to the beginning of the current track. Fast advance, audible (CUE). Hold down as long as required. Switch on the radio. • Insert a CD with the label facing up without the use of force. The CD will be transported to its playing position automatically.
MIX playback Selecting CDs and tracks MIX MAG – CDC-A 05 / CDC-A 071 All tracks of the CD will be played at random. The next disc will then also be selected and played randomly, etc. When the MIX function has been activated, the CD tracks will be played in random order. “MIX” will then appear in the display. In order to switch the MIX function on or off, • press SC/MIX briefly. CDC operation (optional) MIX OFF – The Mix function is deactivated. Discs and tracks will be selected in numeric order.
DEUTSCH “NUMBER” Use this function to scan all of the CD tracks. For CDC operation, the system will scan the tracks of all discs. Use this feature to program and play your favourite CD tracks. Up to 30 CDs can be managed in the CD mode, up to 99 discs in the CDC mode. You can store your preferred display mode which will then be active each time the radio is switched on. If required, • press DIS as many times until the desired setting is displayed. • Hold down the DIS button until you hear a beep.
CD playback with TPM b) Clearing a CD from the TPM: • The TPM function must be switched on (TPM on/off with the TPM button). The tracks stored with TPM will be played in ascending order. Any tracks which were not stored will be skipped over. Clearing TPM information Using the CLR (clear) button, you can clear single tracks, all of the tracks for one CD or the entire Track Program Memory. For CDC operation, you can also clear the TPM information of either the inserted magazine or all magazines.
• Press . The first underscore character will flash. • Select the first character with the help of the rocker switch / . You have the choice between the capital letters A to Z, special characters and the numbers 0 to 9. • Use the rocker switch << >> to move to the next underscore and select a character. You can select up to eight characters for CD and up to seven characters for CDC operation. Use the DSC feature to delete a CD name. • Press DSC.
DSC programming • After having updated the last CD or magazine, press TPM for approximately two seconds (beep). To quit the function, • press DSC. The system has saved the TPM information for all of the CDs which were inserted. For all other discs, the TPM information and CD names have been deleted. DSC (Direct Software Control) allows you to customise certain programmable, basic settings to suit your personal needs and preferences and then store them.
ANGLE Use this setting to alter the viewing angle to your liking from -1 to 0 to +1. BRIGHT You can adjust the display brightness from between 1 to 16. You can also select different values for day and night. LED ON LEARN KC Here you can choose between LED ON or LED OFF. With LED ON, the KeyCard tongue will flash for extra anti-theft protection when the unit has been switched off and the KeyCard removed. To “train” a replacement KeyCard.
S-LO To adjust the seek tuning sensitivity for local reception. LO 1 - high sensitivity LO 3 - low sensitivity The seek tuning sensitivity values can be separately set for AM and FM. CD/CDC UPD Use this function to clear TPM information and CD names during CD and CDC operation, in order to have more storage capacity for new discs available. See “Clearing TPM information and CD names with DSCUPDATE”. AUX VOL FIX Use this function to select the volume at which the radio is set when it is switched on.
DEUTSCH Appendix Specifications FM sensitivity: ENGLISH FRANÇAIS Tuner Wavebands: FM : AM : 4 x 23 W RMS power acc. to DIN 45324 at 14.4 V 4 x 35 W max. power 87.5 – 107.9 MHz 530 – 1710 kHz 0.9 µV at 26 dB signalto-noise ratio ITALIANO Amplifier Output power: NEDERLANDS FM frequency response: 30 - 16 000 Hz SVENSKA CD player Frequency response: 5 - 20 000 Hz PORTUGUÊS ESPAÑOL Questions? Problems? Call 1-800-266-2528 Subject to modifications! 27 Toronto RDM126 us-gb® 27 24.04.
Blaupunkt-Werke GmbH Postfach 77 77 77 D-31132 Hildesheim Germany Robert Bosch Corporation Sales Group – Blaupunkt Division 2800 South 25th Avenue, Broadview, Illinois 60153 1-800-950-BLAU Robert Bosch, SA., DE, C. V. Dr. Lucio 270 Cois. Doctores, Mexico 06720 Made in Germany Fabriqué en Allemagne Hecho en Alemania Fabricado en Alamanha Copyright 1997 by the Robert Bosch Corporation No portion of this work may be reproduced in any form without the written consent of the Robert Bosch Corporation.
