Operating instructions

16
Automatically storing the
strongest stations with Travel-
store
You can automatically store the six most
powerful FM and AM stations of your cur-
rent reception area sorted according to their
signal strength. This function is particularly
convenient on longer trips.
Press the FM
T or AMT button for two
seconds.
“T-STORE” will appear in the display.
The six strongest FM or AM stations will be
automatically stored on the memory bank
“T” (Travelstore). When this process has
been completed, the radio will play the first
station.
If desired, stations can also be stored man-
ually on the Travelstore bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station at the touch
of a button.
Select the waveband by pressing FMT
or AMT. On FM, also choose the corre-
sponding memory bank by pressing
the FMT button as many times until the
desired bank appears in the display.
Press the corresponding preset button
briefly to recall the station.
To select a scanned station and switch
off the Radio-Scan function:
Press SC/MIX briefly.
If no station is selected, the scan function
will be automatically switched off after the
frequency band has been run through com-
pletely. The unit will tune in the station lis-
tened to before starting the scan.
Changing the scan time
The scan time can be changed from be-
tween five to a maximum of 30 seconds.
Please refer to chapter “DSC programming
- SCANTIME”.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also
pick up weaker, distant stations (high sen-
sitivity).
The sensitivity level can be altered in both
modes (see also chapter “DSC program-
ming”).
Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned on all wavebands.
To start Preset Scan:
Press SC/MIX for approximately two
seconds.
All of the stored stations of the adjusted
waveband will be scanned one after the oth-
er “SCAN” and the memory bank and pre-
set position of the currently scanned station
will flash in the display.
To select a scanned station and switch
off Preset Scan:
Press SC/MIX briefly.
Scanning stations with
Radio-Scan
You can also scan all stations which can be
received.
To start the Scan function:
Press SC/MIX briefly.
The scanned frequency or the station name
will start flashing in the display. During the
actual scanning process “FM-SCAN” or
“AM-SCAN” will be displayed.
Toronto RDM126 us-gb® 24.04.2002, 14:33 Uhr16