Operating instructions

6
cleaning. Remove beaters from mixer before
washing.
13. NEVER ATTEMPT TO REPAIR THE POWER
UNIT. NEVER REMOVE THE MOTOR COVER. THE
MOTOR DOES NOT CONTAIN SELF-ADJUSTABLE
OR SERVICEABLE PARTS. A QUALIFIED
SERVICE AGENT MUST MAKE ALL SERVICE
ADJUSTMENTS. REMOVING THE COVER OR
ATTEMPTING TO SERVICE THE UNIT WILL VOID
THE WARRANTY.
14. TURN THE POWER SWITCH OFF WHEN NOT
IN USE
The power switch (ON/OFF switch) is located at
the front right corner, at the bottom edge of the
machine.
15. AVOID TOUCHING THE BLENDER DRIVE
SOCKET AFTER EXTENSIVE USE
The blender drive socket may become hot after
numerous cycles.
16. CLOSE SUPERVISION IS NECESSARY WHEN
THIS APPLIANCE IS USED BY OR NEAR
CHILDREN OR PERSONS WITH REDUCED
CAPABILITIES. Further, children and persons
with reduced capabilities should not play with the
appliance at any time.
17. THE Mix n Blend II™ IS INTENDED FOR HOME
USE ONLY! ANY USE OF THE MACHINE
FOR COMMERCIAL PURPOSES VOIDS ALL
WARRANTIES.
18. ALL REMOVABLE PARTS ARE DISHWASHER
SAFE ON TOP RACK ONLY. DISHWASHER
TEMPERATURE SHOULD NOT EXCEED 220°
FAHRENHEIT.
These precautions are intended to help prevent
personal injury and/or damage to the machine.
SAVE THIS INSTRUCTION
MANUAL FOR FUTURE REFERENCE
Component Overview
1. POWER UNIT
This is the main part of the mixer that includes
the electrical controls, the motor assembly,
drive gears, and the control panel. Each unit has
been factory tested to ensure that all internal
components are in proper working order. The
cover must not be removed. There are no
adjustments that can be made and no serviceable
parts within the power unit. All service must be
performed by the Blendtec factory or authorized
service representatives. Removing the cover may
result in damage to the machine and will void the
warranty.
2. POWER SWITCH
The power switch is located on the lower right
corner of the machine (below the control panel).
Power can be immediately turned off using this
switch.
3. LOW SPEED DRIVE
Because of the great variety of options on the
Mix n Blend II™, two drives are required. The low
Speed drive is located on the lower left section of
the machine and operates the mixing attachments
inside the mixing bowl.
4. HIGH SPEED DRIVE
The high speed drive is located on the upper right
side of the mixer and is used to drive the blender.
5. CONTROL PANEL
The control panel is used to control all functions
of the Mix n Blend II™. The chart below gives a
brief overview of the button functions: