User manual

☞

Place guide (A) on the inside part of the furniture door, up and down

as shown in the figure and mark the position of external holes. After

having drilled holes, fix the guide with the screws supplied.

☞

Fix cover (C) on guide (A) until it clips into place.

☞

Open the appliance door and the furniture door at 90°. Insert the

small square (B) into guide (A). Put together the appliance door and

the furniture door and mark the holes as indicated in the figure.

Remove the squares and drill holes with Ø 2 mm at 8 mm from the

outer edge of the door. Place the small square on the guide again and

fix it with the screws supplied.

☞

Should the lining up of the furniture door be necessary, use the clea-

rance of slots. At the end of operations, it is necessary to check if the

door of the furniture closes properly.

☞

Fix cover (D) on guide (B) until it clips into place.

20mm

50mm

8mm

PR167

R168

R167/1