User's Manual

ManualsBrandsblue hive ManualsBattery ChargersWireless Charging Station with Built-in Smart Watch Holder

Wireless Charging Station with

Built-in Smart Watch Holder

User manual

This charging station allows you enjoy wireless charging easily. Please read

the user manual before using and keep it for future reference.

Specifications:

Input: DC 5 V 2 A

Wireless output: 5 V 1 A

USB output: 5 V 1 A

Frequency: 114.40KHz - 147.97KHz

Charge efficiency: 65%

Charging distance: ≤ 8 mm

Model No. 035-7316-6

Summary of content (6 pages)

PAGE 1
Wireless Charging Station with Built-in Smart Watch Holder User manual Model No. 035-7316-6 This charging station allows you enjoy wireless charging easily. Please read the user manual before using and keep it for future reference. Specifications: Input: DC 5 V 2 A Wireless output: 5 V 1 A USB output: 5 V 1 A Frequency: 114.40KHz - 147.
PAGE 2
Smart watch charger and cable: Arm 1 2 5 3 4 Base INSTRUCTIONS: 1. Place the Smart Watch onto the arm 2. Firmly press the charging cable into the route 3. Run the remaining cable through the slot 4. Firmly press the arm into the base 5. Plug the cable into the USB output.
PAGE 3
Connecting to power supply: 1. Connect USB 2.0 port to the power adaptor (or connect to laptop), and micro USB port to the wireless charging dock. 2. The LED indicator will turn to green, entering into standby mode.
PAGE 4
Charging function: 1. Make sure the wireless charging dock is connected to a power supply, and is in standby status. 2. Put the QI-enabled smart phone on the dock, LED indicator turns to blue for charging. 3. Attach the smart watch to the watch charger for charging. 75% Ch a rge d 80% Ch a rged LED Indicator Note: if the phone case is metal, please remove before charging. Do not use phone cases thicker 5 mm (3/16") for wireless charging.
PAGE 5
FCC Statement： Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 6
Warning: 1. Do not squeeze or drop the charging station. 2. Do not disassemble or throw into fire or water to avoid causing short circuit leakage. 3. Do not use wireless charger in hot, humid or corrosive environments to avoid damage. 4. Do not place wireless charger close to magnetic stripe or chip card (ID card, bank card, etc.) to avoid magnetic failure. 5. Please keep the wireless charger at least 20 cm (7 7/8") from implantable medical devices (heart pacemakers, implantable cochlea, etc.