Full Product Manual
3. Fill suitable lubricant into the tank using a funnel fitted with a filter to avoid
debris entering the tank. Do not overfill and leave approximately 5 mm of
space between the top of the oil and the inside edge of the tank to allow for
expansion (Fig. x).
NOTE: Use engine oil SAE#10W-30 all year round or SAE#30-#40 in
summer and SAE#20 in winter.
Fig. 14
NOTE: Towards the end of the season, it is advisable to put only as
much lubricant in the tank as you n
eed for each cut, so that it is
completely used up before you store the product.
4. Wipe up spilled lubricant with a soft cloth and refit the oil tank cap (29). Use
the multi tool (32) to tighten the cap properly.
NOTE: Always dispose of lubricant, used oil and objects
contaminated with them in accordance with local regulations.
Checking
NOTE: Perform the following test before operating your product.
This product is equipped with an automatic oiling system! The
oiling system automatically delivers the proper amount of oil to the
bar and chain!
Checking the lubrication requires starting the engine. Before
checking, the product must be fully assembled and all instructions
must have been read.
1. Make sure the guide bar (8) and the saw chain (7) are in place when you
check the oil delivery.
2. Start the engine; keep it running at medium power and check if the chain oil is
delivered as shown in the figure (Fig. 15).
1-800-348-5004
DVTUPNFSTFSWJDF!GPDVTPOUPPMTDPN
29