Full Product Manual

procedure:

Set the ignition switch (22) to lower position (STOP position).

Push the choke (21) fully back to OPEN position . Remove the

spark plug (20) and dry it. Pull the recoil starter handle (26) for

several times to drain the fuel from the combustion chamber.

Wait until fuel vapours and refit the spark plug. Clean up any

spilled fuel and move the product at least 3 metres (10’) away

before starting the engine to avoid any accidental fire. Wait the

engine to

coo

l down and then start the product as described in

section “Cold start”.

Stopping

1. Release the throttle interlock (2) / throttle trigger (3) and let the product run

at its idle speed for 10 – 15 seconds.

2. Set the ignition switch (22) to lower position (STOP position) (Fig. 24).

Fig. 24

WARNING! The cutting device (saw chain) will continue to run for

short time even after the engine has been switched off! Wait until

the cutting device has come to

a complete stop

before placing the

product on the ground!

NOTE: The product will become very warm after a long time using;

allow it to cool down completely before restart. If the product

cannot be switched on with warm start procedure, then refer to the

cold start procedure.

5. Basic operating / cutting procedure

1-800-348-5004

DVTUPNFSTFSWJDF!GPDVTPOUPPMTDPN