Full Product Manual
1.9. Carburetor is
flooded with fuel
1.9. Remove air filter
and pull recoil
starter handle
continuously until
carburetor clears
itself and install air
filter
1.10. Faulty ignition
module
1.10. Contact an
authorised service
centre or a
similarly qualified
person
2. Engine stops 2.1. Not enough fuel in
fuel tank
2.1. Add fuel
2.2.Saw chain is blocked 2.2. Remove blockage
3. Engine difficult to
start or loses power
3.1. Dirt, water or stale
fuel in the tank
3.1. Drain fu
el and
clean tank. Fill tank
with clean, fresh
fuel
3.2. Air filter is dirty 3.2. Clean air filter
3.3. Fuel filter/fuel tube
clogged/worn
Contact
authorised service
centre or a similarly
qualified person
3.4. Vent hole in fuel
tank cap is clogged
3.4. Clean or replace
fuel tank cap
4. Engine operates
erratically
4.1. Spark plug is
defective
4.1. Install new,
correctly gapped
plug
4.2. Spark plug gap is
incorrect
4.2. Set gap between
electrodes at
0.6 - 0.7mm
4.3. Air filter is dirty 4.3. Clean air filter
4.4. Engine requires to
warm up
4.4. Allow engine to
completely warm
up and run at idle
speed for 3min
minutes
1-800-348-5004
DVTUPNFSTFSWJDF!GPDVTPOUPPMTDPN
57