Service manual

-18-
Revision 1/F3503
Two
Screws
Two Screws
6.3.6 BAKE TIMER
1) Remove bake timer knob by pulling it
firmly away from control panel.
2) Open control panel (refer 6.2.1) and undo
two screws securing timer.
Fan Element
3 Screws
6.3.8 ELEMENT
6.3.7 THERMOSTAT
1) Pull knob off front of thermostat.
2) Open control panel (refer 6.2.1) and undo
two screws securing thermostat.
3) Transfer wires to new timer.
4) Withdraw old timer and insert new timer,
securing with screws.
5) Replace knob.
Two Screws
Figure 6.3.6
5) Withdraw old thermostat phial through
rear of oven.
6) Insert new thermostat.
7) Re-assemble in reverse order.
3) Transfer wires to new thermostat.
4) Remove service panel (refer 6.2.2) and
from inside of oven loosen two screws
holding thermostat phial bracket.
Figure 6.3.7
Figure 6.3.8
1) With service panel and baffle removed
(refer 6.2.2 and 6.2.3) remove the wires
from the element.
2) Unscrew the element from inside the
oven.
3) Pull element carefully to remove.
4) Replace and re-assemble in reverse
order.
Figure 6.3.9
Element Ratings (at room temperature)
230-240V Fan Element 24 ohms ±5%
220V Fan Element 20 ohms ±5%
Centre Nut
6.3.9 FAN
1) With baffle removed (refer 6.2.3) undo the
centre nut.
NOTE: LH thread - Turn clockwise to
loosen.
2) Replace and reassemble in reverse order.
NOTE: Reassemble with one washer behind
fan and one washer in front.
Figure 6.3.10