Service manual

-20-
Revision 1/F3503
Two Screws
3) Uncrimp the retaining lugs of the window
spacer and remove the spacer and glass.
Retaining
Lugs
Figure 6.3.16
6.3.13 DOOR SEALS
1) Open oven door.
2) To remove, hold at their centre point and
pull forward until they unclip
3) Refit new seals.
Note: Fit top and bottom seals first, with
open side of seal facing
downwards. Fit side seals with
open side facing outwards.
4) To replace, ensure the silicone rubber seal
has not been displaced. Clean the glass
and refit it. Place the window spacer in
position and crimp the retaining lugs over
to hold the glass in place. Refit outer
glass as above.
6.3.14 DOOR HANDLE
1) Remove the door (refer 6.3.11).
2) Undo three screws and remove the top
trim and handle assembly, taking care not
to dislodge the outer glass.
3) Undo two bolts securing handle to top
trim. Replace handle and reassemble in
reverse order.
6.3.15 DOOR HINGES
1) Remove outer glass (refer 6.3.12).
2) Undo two screws securing hinge assembly
to oven door.
Figure 6.3.17
3) Withdraw hinge assembly and replace.
Reassemble in reverse order.
Figure 6.3.18
Two Bolts
6.3.16 HINGE COUNTER BRACKETS
1) Remove door (refer 6.3.12).
2) Remove screws from back of oven
securing wrapper to oven.
Figure 6.3.19
3) Turn oven onto its back and remove three
screws at each side securing wrapper,
and two securing insulation panel.
Figure 6.3.20
4) Undo three screws and remove lintel
cover.
5) Remove control panel (refer 6.2.1) and
microswitch bracket (refer 6.3.2). Place
inside oven.
8 screws