Specifications

Gas Conversion and Specifications

Gas Type Identification Label

On completion of the gas conversion, replace gas type identification label, located:-

- At the rear of the unit, above the gas connection.

- Beside the Rating Plate.

Commissioning

Before leaving the converted installation;

1. Check all gas connections for leakages using soapy water or other gas detecting equipment.

2. Check the following functions in accordance with the operating instructions specified in the

'Operation' section of this manual.

• Light the Pilot Burner.

• Light the Main Burner.

• Check the Low Fire burner operation.

• Check the High Fire burner operation.

• Ensure that all the controls operate correctly.

• Ensure that the operating pressure remains correct.

NOTE: If for some reason it is not possible to get the appliance to operate correctly, shut off the

gas supply and contact the supplier of this appliance.

WARNING:

DO NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES.