Specifications

Clearances

NOTE: Only non-combustible materials can be used in close proximity to this appliance.

* Side clearances can be 50mm when the adjacent surface is at least 100mm below the cooking

surface.

Assembly

NOTE:

• All Models are delivered completely assembled. No further assembly is required. Refer to

the information below for assembly instructions.

• This appliance is fitted with adjustable feet to enable the appliance to be positioned

securely and level. This should be carried out on completion of the gas connection. Refer

to the ‘Gas Connection’ section.

Optional Accessories (Refer to Replacement Parts List)

• Plinth Kit. For installation details, refer to the instructions supplied with each kit.

1. Check that all the feet (rollers) are securely fitted.

2. Adjust the feet to make the appliance steady and level.

Gas Connection

NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON.

1. It is essential that the gas supply is correct for the appliance to be installed and that adequate

supply pressure and volume are available. The following checks should therefore be made before

installation:-

a. Gas Type the appliance has been supplied for is shown on the

coloured stickers located above the gas connection and next to

the rating plate. Check that this is correct for the gas supply

the appliance is being installed for. The gas conversion

procedure is detailed in this manual.

b. Supply Pressure required for this appliance is shown in the

'Specifications' section of this manual. Check the gas supply to

ensure adequate supply pressure exists.

c. The Input Rate of this appliance is stated on the Rating Plate

and in the 'Specifications' section of this manual. The input

rate should be checked against the available gas supply line

capacity. Particular note should be taken if the

appliance is being added to an existing installation.

NOTE: It is important that adequately sized piping runs directly to the connection joint on the

appliance with as few tees and elbows as possible to give maximum supply volume.

2. Fit the gas regulator supplied, into the gas supply line as close to the appliance as possible.

Installation

Combustible Surface Non Combustible Surface

Left / Right hand side 50mm 0mm

Rear 50mm 0mm

Fig 1

Rating Plate

Location