Use and Care Manual

Quick Start
Troubleshooting
Trouble Number 02: Main Brush
Trouble Number 02
Main Brush
UV
DIRT
TROUBLE NR.
CAPACITY
AUTO SPOT WALL FOLLOW DOCK
MIN. CLEANING
CHARGING
READY
What to do:
Remove the screw on the main brush using
a at head screwdriver.
Clean the brush and the brush compartment
from end to end using Bob’s cleaning tool.
When done, replace the brush cap and
insert the square end of the brush into the
square notch inside Bob. Lastly, replace the
screw.
1.
2.
Parts You’ll Need: Flat Head Cleaning Tool
Screwdriver
You may use scissors to cut away
entanglements of hair, or tweezers to
unclog the notches inside Bob.
Quick Tip:
Bob’s main brush is not designed to clean
shag carpet or rugs with long fibers. If
you’d like Bob to clean shag carpet or long-
fibered rugs, you may remove his main
brush and allow him to vacuum without it.
3.
7877