Use and Care Manual

UV
DIRT
TROUBLE NR.
CAPACITY
AUTO SPOT WALL FOLLOW DOCK
MIN. CLEANING
CHARGING
READY
The words DIRT, MIN. CLEANING, CAPACITY,
and CHARGING should be lit.
Lift Bob about 6 inches (15 cm) off the ground,
and the 4 words should turn off.
Step 1:
Edge Sensors
Drag a thick, at, and light-colored surface
around Bob’s bumper.
The words UV, AUTO, SPOT, WALL FOLLOW,
and DOCK should light up one at a time as you
move your surface from the left side of Bob’s
bumper around to the right side.
The far right sensor is less sensitive than the
others, so it may not respond the rst few passes.
Step 2:
Wall Sensors
Step 3:
Charging Station
Quick Start
Home Checkup Test
Home Checkup Test: Steps 1 to 3
UV
DIRT
TROUBLE NR.
CAPACITY
AUTO SPOT WALL FOLLOW DOCK
MIN. CLEANING
CHARGING
READY
UV
DIRT
TROUBLE NR.
CAPACITY
AUTO
SPOT WALL FOLLOW DOCK
MIN. CLEANING
CHARGING
READY
The charging station must be synced and
plugged in for this step.
Press the UV button on Bob’s cover.
Place Bob about 5 inches (18 cm) away from
the charging station, with his front facing the
sensor on top of his station. Bob should display
the number 77 on his screen when properly
aligned. If Bob does not display the number 77,
clean the window on the charging station and
the small hole in the center of Bob’s bumper.
UV
DIRT
TROUBLE NR.
CAPACITY
AUTO SPOT WALL FOLLOW DOCK
MIN. CLEANING
CHARGING
READY
To skip ahead in the checkup
test, follow the button sequence
(bolded in red).
To exit the checkup test, ip
Bob’s power switch OFF and
then ON.
10099