Use and Care Manual

Quick Start
FAQs
Bob just stopped cleaning
and his screen turned off.
What do I do next?
Bob may be in standby mode. If this is the
case, pressing any button on his cover or
remote should wake him. If this does not
work, his battery is likely completely drained.
Place Bob on his charging station and allow
him to fully charge.
How do I know that Bob is
fully charged and ready to
clean?
When Bob is charging, the battery bars and
the word CHARGING ash on his screen.
When Bob is fully charged, the word READY
is lit on his screen.
How often should I clean
Bob’s brushes?
To maximize Bob’s efciency, it is best to clean
his brushes about once a week. Remember
to also clean the notches inside Bob that hold
the brushes in place.
Bob is having trouble nding
his charging station.
First, sync the charging station. Start by
ipping Bob’s power switch OFF. Then, hold
down the ADJUST/SELECT button on the
station while ipping Bob’s power switch ON.
Bob will chirp twice to conrm the sync was
successful. If after syncing the station Bob
is still having trouble nding it, relocate the
station to a more easily accessible location
with more space around it. Make sure the
station is against a wall on a hard, at surface.
How often should I empty the
dustbin?
Depending on the size of the room and the
amount of debris piled up, Bob may be able to
perform up to 6 cleaning cycles before lling
his dustbin.
Simply remove the dustbin and check to see
if emptying is necessary.
I am having problems
removing Bob’s brushes.
Unscrew the brushes and gently wriggle them
while pulling up. Do not force the brushes
out, as this can damage them. You may use
scissors to cut away entanglements of hair, or
tweezers to unclog the notches inside Bob. It
is best to clean Bob’s brushes about once a
week to prevent buildup.
Why is Bob beeping?
Bob beeps periodically while in standby mode
to let you know that his battery is draining.
To conserve his battery, ip his power switch
OFF or place him on his charging station to
charge.
Bob also beeps when he encounters a
problem and needs assistance. In addition
to beeping, he will display a trouble number.
Consult the Troubleshooting section of this
manual for solutions.
My Bob won’t turn on no
matter what I do.
First, make sure Bob’s power switch is turned
ON. The power switch is located on Bob’s left
side. If Bob’s power switch is turned ON and
he is not responding to his cover buttons, then
his battery has likely drained too low for him
to operate. Place Bob on his charging station
and allow him to fully charge.
To watch Bob’s how-to videos, visit
www.bobsweep.com/pethair-support or
download the bObsweep App on your iOS or
Android device.
106105