Owner`s manual

NOTICE :

The treadmill should be placed on a level surface. If the treadmill is not level, the

belt will continuously track to low side of the treadmill.

WALKING BELT TENSION

As walking belts tend to stretch slightly with use, the belt may occasionally need to be

tightened. If belt is too loose, you may find the belt stops while running or walking,

while the motor continues to run. DO NOT OVERTIGHTEN THE BELT. This will

cause reduced motor performance and roller damage.

When properly tensioned, you should be

able to lift the side of the belt about 2-3

inches (5-7.5 centimeters). A quick test for

belt tension: you should be able to fit three

fingers under the edge of the belt.

To tighten belt:

Using the hex key provided with the

treadmill, place it in the hole in the left rear

end cap and into the socket of the

adjustment screw. Turn one full turn

clockwise. Then place the hex key in the

hole in the right rear end cap and turn one

full turn clockwise. Check the tension of

the belt. Continue to do this until the belt is

at the correct tension. Make sure to adjust

both sides equally to ensure correct belt

alignment.