Owner`s manual

U-1/U-2 User Programs: After selecting one of the user programs, press

ENTER to confirm. Adjust the speed and incline for segment one and press

ENTER. Continue to adjust the speed and incline for each segment and

press ENTER. Press START to begin the workout. If a speed or incline

value is changed during usage, the monitor will store the value of the speed

and incline at the end of each segment and will retain these values.

Metric/Miles:

If you want the treadmill to display the values in kilometers, you can switch to

kilometers as follows:

1. During the power ON - manual mode, first hold the ENTER button then press the

SELECT button together to enter the Engineering Mode.

2. Calories window shows model no., Speed window shows software version,

Incline window shows year. Time window shows date.

3. Press ENTER button – the Incline window shows ISP, Time window shows ISP

version, Speed window shows 001, Distance window shows LDU and Calories

window shows LDU version.

4. Press ENTER button again to enter KM/MILE switch mode, Press SPEED + - or

ELEVATION + - to select KM or MILE.

5. Press ENTER button again and the window will show total distance.

6. Press ENTER button again and the window will show total hours.

7. Press ENTER button to go back to ON position.

Odometer:

An odometer showing accumulated distance will appear in the time window for one

second when the safety key is placed on the monitor.

Time-Out:

If the treadmill is turned on, and the belt is not moving, the monitor will shut off after

five minutes.

Re-start :

If the treadmill is stopped during use, when the START button is pressed again, the

treadmill will ramp-up the speed to where it was stopped. If the treadmill is stopped

for 5 minutes or more, Power is lost and the treadmill will have to be re-started.