Operator`s manual

Belt Guard Removal
•
WARNING: Engine should
be run-
ning only
when belt guard is se-
cured in place.
1. Tilt the hood.
2. Pull out both retaining pins.
3. Lift and remove the belt guard assem-
bly.
Drive Belt Removal and
Installation
•
WARNING: Never start or run en-
gine without the drive belt install-
ed. Running
an unloaded engine is dan-
gerous.
1. Remove the belt guard.
2. Unlock and raise driven pulley support.
A004003006
Driven pulley
support
3. Open the driven pulley by twisting and
pushing the sliding half. Hold in fully
open position.
4. Slip slackened belt over the top edge
of the sliding half.
A004003008
5. Slip the belt out from the drive pulley
and remove completely from vehicle.
A004003009
To install the drive belt, reverse the pro-
cedure, however
pay attention to the fol-
lowing.
------------- 23