Operator`s manual
Suspension
Remove any dirt or rust. Grease
all
com-
ponents equipped
with
grease fittings.
Wipe
off
surplus. Replace worn slider
shoes.
Skis
Wash or brush all dirt or rust accumu-
lation from the skis. Grease the ski legs
at the grease fittings.
•
WARNING:
Check
the
condition
of the
skis,
ski
runners and springs
Replace if weak
or
worn more than half.
Controls
Lubricate the steering mechanism. Inspect
all
components for tightness, (spring cou-
pler bolts, steering arm locking bolts, tie
rods,
ball
joints,
etc.)
Tighten if
necessary.
Oil
moving joints of the
brake
mechanism.
•
WARNING:
Do
not lubricate
the
throttle and/or brake cables and
housings. Avoid getting
oil
on
the brake
pads.
Coat all electrical connections and swit-
ches
with
a greaseless metal protector.
If unavailable, use petroleum jelly.
Chaincase
Drain the chaincase and refill to proper
level, using fresh chain case oil (
P/N
413
8019
00-200
ml).
To
drain, remove the
chaincase cover.
Drive Pulley
Inspection
and
cleaning must
be
perform-
ed
by the dealer at the end
of
each sea-
son.
Engine and Primer Lubrication
Engine internal parts must
be
lubricated
to protect them from possible rust for-
mation during the storage period.
To
perform the storage procedures (en-
gine and primer valve) proceed
as
fol-
lows:
1.
Lift the rear of the vehicle and sup-
port it
off
the ground.
•
WARNING: Ensure the track
is
free
of
ails particles
which
could be
thrown
out
while it
is
rotating. Keep
hands, tools,
feet
and clothing clear
of
track.
Ensure
no-one
is
standing
in
close
proximity to
the
vehicle .
2.
Start the engine and allow it to run
at
idle
speed
until the engine reaches
its operational temperature.
3. Stop the engine.
4.
Disconnect the inlet primer
hose
from
the primer
valve.
A002002009
Inlet (Oblique
ygl
Outlet
hose
(Straight
coupling)
5.
Plug
inlet primer
hose
to prevent gas-
oline from draining.
6.
Using
an
appropriate hose, connect
one end of the hose to the inlet
of
the primer valve and place the other
end
in
a Bombardier Snowmobile In-
jection
Oil
container.
7.
Activate the primer
in
order to fill it
with
oil.
8.
Restart engine and run at idle.
________________________
35