Operator`s manual

9. Using the primer valve, inject oil un-
til the engine dies or until a sufficient
quantity of oil
has entered the engine
(approximately 25 complete strokes
of the primer).
10. The engine stopped, remove the spark
plugs and pour approximately
85 ml
(3 imp. oz.) of oil into the cylinders.
11. Crank the engine to allow the crank-
shaft to turn 2 or 3 revolutions.
12. Reinstall the spark plugs and the in-
let primer hose.
Do not run engine during storage pe-
riod.
Gas Tank and Carburetors
Remove the cap then using a syphon, re-
move the gasoline from tank .
•
WARNING: Gasoline
is flamma-
ble and explosive under certain
conditions. Always manipulate
in a well
ventilated area. Do not smoke
or allow
open flames or sparks
in the vicinity.
Carburetors must be dried out completely
to prevent gum formation during the stor-
age period.
Once the fuel tank
is emptied, remove
the float chamber drain plug from car-
buretors. Drain carburetors.
A002002010
Reinstall plug.
Check
all fuel lines, replace if necessary.
Battery
(Electric Starting)
1. Disconnect the battery cables and
remove the battery retainer cover.
W' CAUTION: Be careful not to ground
T positive terminal with the chas-
sis. Always disconnect black negative
cable first.
2. Remove the battery vent tube from
the vent hole.
3. Lift out the battery.
4.
Clean outside surface of battery with
solution of baking soda and water.
Remove
all deposits from posts then
rinse
with clear tap water.
.,.,. CAUTION: Do not allow cleaning
T solution to enter battery interior
since it will destroy
the electrolyte.
5. Check electrolyte level. Refill if neces-
sary with distilled water. Fully charge
battery at a maximum rate of
2.0
A.
.,.,. CAUTION: Prior to charging the
T battery, always remove it from the
vehicle
to prevent electrolyte spillage.
36 ________________________ __