Owner`s manual
BONAIRE DURANGO WINDOW COOLER
Installation
• Ensure there is a 100mm (4”) clearance above the unit so the rear panel can be
remove for service
• Ensure that the unit is installed level in the vertical and horizontal positions as
illustrated, prior to fixing the cooler.
• Use the two ‘Wallmate’ screws provided to fix the cooler to the outside of the house if a
‘stucco-type’ wall is being used. (Note that if the unit is not hard up against the wall,
these fixing screws will go into the spacer block all ready installed).
• For solid walls, brick or masonry, use suitable masonry lag anchors.
• Place the unit in position, mark screw positions, remove unit then drill pilot holes for
timber walls (1/8” or 3.2mm).
• Replace unit in window, fit screws.
Page 8
WEAC628