Owner manual

ENG

Disengage the retaining spring, leaving it inserted in one of the two holes of

the bearing ring to avoid losing it.

Spread the bearing rings and remove from their groove.

CV JOINT SHIELD ASSEMBLY

Grease the seats and install the shield support bearings.

Fit the bearing ring onto the inner yoke with the reference pin facing the

drive tube.

Install the bearing ring on the CV body with the reference pins facing the

inner yoke. The bearing ring is equipped with a grease tting, used only for

50° CV joints. This grease tting is not used with 80° CV joints.

Connect the retaining spring to the two edges of the bearing ring.

Insert the shield aligning the radial holes with the reference pins of the bearing

ring and the hole on the bottom with the reference pin of the small bearing.

The grease tting of the bearing must be aligned with the holes on the shield.

Check that the radial holes in the shield are aligned with the holes in the

reference pins of the bearing ring and that the reference pin is inserted.

Tighten the 6 anged screws of the shield. Use of an electric screwdriver is not

recommended.

Fit the base cone with the tube, inserting the reference pin of the bearing in

the hole provided in the base cone. The grease tting of the bearing is in the

hole of the base cone.

Tighten the 3 screws. Use of electric powered screwdrivers is not recommended.

HOW TO SHORTEN THE DRIVE SHAFT

Bondioli & Pavesi advises against altering its products. If modifications are required,

we recommend that you consult your implement dealer or a qualified service center

before proceeding. If the driveline is too long adopt the following procedure.

Remove the shielding.

Shorten the drive tubes by the required length.

Telescoping tubes must always overlap by at least 1/2 of their length in

normal operation and at least 1/3 of their length in all working conditions.

During maneuvers, when the driveline is not rotating, the telescoping tubes must

have a suitable overlap to maintain the tubes aligned and allow them to slide freely.

Carefully deburr the ends of the tubes with a file and remove all filings from

the tubes.

Shorten shield tubes one at time by cutting the same length that was cut

from the drive tubes.