Operation Manual

Generally, combined detergents produce sufficient results under certain usage conditions
only. Such detergents contain rinse aid and/or salt in preset amounts
Points to consider when using this type of products:
• Always make sure to check the specifications of the product you will use or whether
or not it is a combined product.
• Check if the detergent used is appropriate for the hardness of mains water that
machine is appertaining to.
• Observe the instructions on packagings when using such products.
• If such detergents are in the form of tablets, never put them into the interior section
or the cutlery basket of the dishwasher. Always put the tablets into the detergent
compartment in the detergent dispenser.
• They produce good results for certain types of usage only. If you are using this type
of detergents, you need to contact the manufacturers and find out about the suitable
conditions of use.
• When the conditions of use of such products and the machine settings are
appropriate, they ensure savings in salt and/or rinse aid consumption.
• Contact the detergent manufacturers if you are not obtaining good wash results (if
your dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents.
The scope of warranty for your machine does not cover any complaints caused by
the use of these types of detergents.
Recommended usage: If you are using a combined detergent, then add rinse agent into
your
machine ,switch the rinse agent settings into its lowest (1) position and active the tablet
detergent button in order to obtain better results.If the water hardness level is above level
4,then
it is necessary to fill in the salt container with salt._t is not recommended to use combined
detergents in fast programs.
Warning: Should any problem, which you have not encountered before, arise with the
use of this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
• Fill the salt and rinse aid compartments.
• Adjust the water hardness setting to the highest position ( 6 ) and run an empty-
wash.
• Adjust the water hardness level.
• Make the suitable rinse aid setting.
Filling with rinse aid and making the setting
Rinse aid is used to prevent the stay of white water drops,
lime stains, white film strip-shaped stains that may form on
the dishes, as well as to increase the drying performance.
Contrary to the popular beliefs, it is used not only for
obtaining shinier dishes but also for obtaining sufficiently
dried dishes. For this reason, care should be taken that
there is adequate amount of rinse aid in the rinse aid
compartment and only polishing material produced for use
at dishwashers should be used.
If the rinse aid lamp on the control panel becomes on fill the
rinse aid
compartment with rinse.
To put rinse aid, remove the rinse
aid compartment cap by turning it.
1
14