Operation Manual

Notes:
NVR recordings only: The icon in the Image pane bar changes to . Click to stop
recording. If you do not click to stop recording, manual recording stops after the configured
manual recording time. In the Timeline of the camera, the manual recording is displayed as
alarm recording.
VRM recordings only: You cannot manually stop recording. The recording stops after the
configured alarm recording time. In the Timeline of the camera, the pre-alarm recording is
displayed as alarm recording, if pre-alarm recording is configured in Configuration Client.
Starting a pre-configured camera sequence
Main window
With a camera sequence, a group of cameras are displayed one after the other. The pre-
configured camera sequences are configured in the Configuration Client and appear in the
Logical Tree.
A sequence can be configured to use more than one Image pane. If there are not enough
Image panes to display the whole sequence, only those Image panes are displayed which fit
into the Image window. The remaining Image panes are not displayed and an appropriate
message is displayed.
Under the following conditions, a sequence is not being displayed:
– Video loss
– Connection to the camera lost
– No permission to display the camera
– Camera not configured
In addition, for sequences displayed on an analog monitor via a decoder, DiBos cameras
cannot be displayed.
Notice!
When the configuration is changed and activated, a camera sequence (pre-configured or
automatic) usually is continued after restart of the Operator Client.
But in the following cases the sequence is not continued:
A monitor where the sequence is configured to be displayed has been removed.
The mode of a monitor (single/quad view) where the sequence is configured to be displayed
has been changed.
The logical number of a monitor where the sequence is configured to be displayed is
changed.
To start and control a camera sequence:
1. Drag the required sequence from the Logical Tree window to an Image pane.
The sequence is displayed indicated by the symbol.
2. Click a playback control icon of the Image window toolbar to control the sequence.
Starting an automatic camera sequence
Main window
With a camera sequence, a group of cameras are displayed one after the other.
You configure the dwell time for these sequences in the Options dialog box (Extras menu,
Options... command).
Under the following conditions, a sequence is not being displayed:
6.8
6.9
28 en | Displaying camera images Bosch Video Management System
2013.07 | V1 | Operator Client Operator's Manual Bosch Sicherheitssysteme GmbH