Installation instructions

Page 11

2. Measure the distance (x) between the bottom edge of

the housing for the recirculation module and the

bottom edge of the back-pressure ap.

A Recirculation module

B Clamps

C Flue duct

D Exhaust air duct

3. Shorten the exhaust air pipe to the length measured.

4. Remove the recirculation module.

5. Push the exhaust air pipe onto the bottom side of the

recirculation module.

6. Position the recirculation module with exhaust air pipe

over the air extraction duct of the extractor hood.

7. Use 4 screws to fasten the recirculation module to the

angle bracket.

8. Secure connections with clamps.

Connect Electrical Supply

WARNING

RISK OF ELECTRIC SHOCK

Before wiring the appliance, interrupt the main electrical

circuit at the electrical control cabinet. A circuit with 120

VAC, 15 or 20 Ampere is required.

Grounding notes: this appliance is equipped with a

distributor box with 3 cables. Use the green-yellow cable

for grounding the appliance. Connect the green-yellow

cable to the grounding cable on the house connection to

prevent electric shock. Do not under any circumstances

damage or remove the green-yellow cable. Non-adheren-

ce can cause deadly injuries or electric shock.

1. Remove the left cable passage and the cover of the

motor controller. Fasten the connecting piece for the

installation pipe (listed in cULus) to the cable

passage.

A Cable passage

B Cover of the motor controller

2. Connect 1/2” (12.7 mm) installation pipe to motor

controller.

A Installation pipe

B Power connection

C Cable connector listed in UL