Operation Manual

Install the MIC (standard) PSU
MIC PSU Overview
!
Caution!
Use only the power supply specified for your specific model of camera.
Bosch provides a range of power supply units (PSUs) for MIC Series cameras. These units
have a variety of common voltages and provide all the connections needed for power,
telemetry and video.
Model Number Input Voltage Dimensions
(H x W x D)
Weight
MIC-24PSU-2 24 VAC 90 x 260 x 160 mm
(3.54 x 10.24 x 6.3 in.)
3.2 kg (7.1 lb)
MIC-115PSU-2 115 VAC 90 x 260 x 160 mm
(3.54 x 10.24 x 6.3 in.)
3.2 kg (7.1 lb)
MIC-240PSU-2 230 VAC 90 x 260 x 160 mm
(3.54 x 10.24 x 6.3 in.)
3.2 kg (7.1 lb)
Table 5.1: PSUs for MIC612
Each MIC PSU provides all of the connections needed for power, video, and telemetry for a
single MIC camera. Each MIC PSU has CE and FCC approval and has a cast-aluminum
enclosure that is weather-resistant (rated IP65). Features include:
– A provision for driving various optional interface cards mounted internally to the MIC
power supply enclosure (for example, an 8-input alarm card (MIC-ALM))
– A provision for a signal interface card (MIC-BP4) to connect telemetry to Bosch Biphase
equipment
– Screw termination of all cables (composite, telemetry, and ancillary) into and out of the
enclosure
– Earth isolation and termination within the unit to control video earthing correctly and
thus prevent earth loops
Each MIC PSU ships with the following parts:
– Three (3) M12 cable glands for telemetry, video and ancillary equipment
– One (1) M16 gland for connection of the shielded composite cable to the MIC camera
– One (1) 1/2 in. NPT cable gland for the power cable connection
– One (1) 1/2 in. NPT and one (1) M12 blanking plug
About the MIC Shielded Composite Cable
All connections (power, telemetry, video) to the MIC camera are provided through the screw
terminal connections in the MIC power supply. MIC shielded composite cables are multi-
conductor cables of various lengths (and gauges ranging from 14 - 18) that provide all power,
video, and telemetry connections between the MIC PSU and the MIC camera. The cables are
pre-made with a female terminated connector (14-pin) at one end for attachment to the male
connector installed into the base of the camera. The other end of the cables has free (non-
5
5.1
5.2
14 en | Install the MIC (standard) PSU MIC612 Thermal Camera
2016.03 | 2.2 | F.01U.249.416 Operation Manual Bosch Security Systems