Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Install the MIC (standard) PSU
- MIC PSU Overview
- About the MIC Shielded Composite Cable
- Composite Cable Color-coding
- Earth Link on PCB
- Fuse Ratings
- Alarm Inputs
- Layout of MIC Power Supply Units (PSUs)
- Installation Warnings and Prerequisites
- Installation Instructions (Power Supply)
- Commissioning the Camera with Heater Option Fitted
- Simultaneous IP and Analog Video/Control ("Hybrid" Operation)
- Fit the Sunshield (MIC612)
- Getting Started
- Controlling the Camera
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Operation of the Thermal Camera
- Common User Commands
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
Figure 5.10: Position of LEDs - MIC Series IR power supply PCB
Number LED Description
1 LED 1
LED 2
Indicates that 18 VAC is available from the power supply and that the
supply fuses are intact.
2 LED 3 Illuminates when the washer drive is on.
3 LED 4 Monitors the internally generate +5 V.
4 LED 5 Illuminates when the IR lamp supply is turned on by the camera
telemetry.
5 LED 6 Status LED. Pulses On/Off when Multi Alarm is selected.
6 LED 7-10 Illuminate when the associated alarm is active.
30. Re-attach the enclosure lid and tighten the four (4) captive screws on the cover to ensure
that the enclosure is watertight.
Commissioning the Camera with Heater Option Fitted
To enable the heaters, you must change two links on the printed circuit board (PCB) of the
power supply. Follow these steps:
1. Disconnect the power supply from the power source.
2. Locate Link 1 and Link 2 on the PCB, next to terminal block HD6. The default setting is
0V.
5.10
28 en | Install the MIC (standard) PSU MIC612 Thermal Camera
2016.03 | 2.2 | F.01U.249.416 Operation Manual Bosch Security Systems