Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Install the MIC (standard) PSU
- MIC PSU Overview
- About the MIC Shielded Composite Cable
- Composite Cable Color-coding
- Earth Link on PCB
- Fuse Ratings
- Alarm Inputs
- Layout of MIC Power Supply Units (PSUs)
- Installation Warnings and Prerequisites
- Installation Instructions (Power Supply)
- Commissioning the Camera with Heater Option Fitted
- Simultaneous IP and Analog Video/Control ("Hybrid" Operation)
- Fit the Sunshield (MIC612)
- Getting Started
- Controlling the Camera
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Operation of the Thermal Camera
- Common User Commands
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
To fit the sunshield, follow these steps:
1. Turn on the power to the camera so that you can rotate the camera head up to fit the
bottom half of the sunshield (see step 8).
2. Rotate the camera under power—do not rotate by hand—until the bottom of the camera
head is facing up.
3. Remove the four (4) retaining bolts from the lid of the camera.
4. Place a stand-off into each screw hole and tighten using a flat head screwdriver.
5. When all four (4) stand-offs have been fitted, align the holes in the sunshield with the
corresponding stand-offs. Push the sunshield until it fits snugly onto the camera head.
6. Fix the sunshield to the stand-offs using the M3 washers and screws.
7. Rotate the camera under power—do not rotate by hand—until the top of the camera head
is facing up.
8. Repeat steps two through six on the top lid of the camera. When fitted properly, both
halves of the sunshield should align and meet at the back of the camera head.
32 en | Fit the Sunshield (MIC612) MIC612 Thermal Camera
2016.03 | 2.2 | F.01U.249.416 Operation Manual Bosch Security Systems