Operation Manual

Setting the Addresses of the Two Cameras of the MIC612
After the MIC612 camera is on, you must set the camera address. The optical camera and the
thermal camera of the MIC612 have different addresses. The address of the optical camera is
set via the OSD and FastAddress. The address of the thermal camera is set via the OSD and a
unique address. From the factory, the default address of the optical camera is "0" and the
default address of the thermal camera is the address of the optical camera + 1.
The figure below illustrates the connection configuration of a MIC612, a matrix switcher, a
monitor, and a keyboard.
Figure 7.1: MIC612 Connection Configuration
1
Viewing window of optical camera 5 Matrix switcher
2 Viewing window of thermal camera 6 Monitor
3 Connection from optical camera to
matrix switcher
7 Keyboard
4 Switchable connection (via Aux
commands) from optical camera or
thermal camera to matrix switcher
FastAddress, Bosch Protocol
In Bosch protocol, there are three (3) FastAddress commands:
– ON-999-ENTER: Displays and programs all cameras without an address in the system.
7.4
7.5
MIC612 Thermal Camera Getting Started | en 35
Bosch Security Systems Operation Manual 2016.03 | 2.2 | F.01U.249.416