Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Install the MIC (standard) PSU
- MIC PSU Overview
- About the MIC Shielded Composite Cable
- Composite Cable Color-coding
- Earth Link on PCB
- Fuse Ratings
- Alarm Inputs
- Layout of MIC Power Supply Units (PSUs)
- Installation Warnings and Prerequisites
- Installation Instructions (Power Supply)
- Commissioning the Camera with Heater Option Fitted
- Simultaneous IP and Analog Video/Control ("Hybrid" Operation)
- Fit the Sunshield (MIC612)
- Getting Started
- Controlling the Camera
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Operation of the Thermal Camera
- Common User Commands
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
Keyboard Command User Action Description
0-Pattern Press Initiate recording continuous playback based upon
current Recording setting (A or B) in the Setup
Menu.
Press and hold Initiate recording based upon current Recording
setting (A or B) in the Setup Menu. Press ACK to
end recording.
1-Pattern Press Initiate Recording A continuous playback.
Press and hold Initiate Recording A. Press ACK to end recording.
2-Pattern Press Initiate Recording B continuous playback.
Press and hold Initiate Recording B. Press ACK to end recording.
3-Pattern Press Initiate the standard preset tour (Tour 1).
4-Pattern Press Initiate the custom preset tour (Tour 2).
1 - Aux On / Aux Off Press Activate / deactivate alarm output 1.
This command is supported with Non-IR models
only if an optional 8-input alarm card is installed in
the PSU powering the camera.
2 - Aux On / Aux Off Press Activate / deactivate alarm output 2.
This command is supported with Non-IR models
only if an optional 8-input alarm card is installed in
the PSU powering the camera.
5 - Aux On / Aux Off Press Toggle switchable video output of MIC612 camera
between visible and thermal output.
91 - Aux On Press Activate Zone Scan (display zone titles).
92 - Aux On Press Deactivate Zone Scan (re-move zone titles).
Special Preset Commands, Pelco Protocol
Some Pelco mode preset commands have a special meaning and override the normal Pelco
preset function as follows:
Preset Command Description
33-PRESET Pans the camera 180° (Flip).
34-PRESET Goes to Zero Pan (original home position).
80-PRESET Toggles the Synchronization Mode between Line Lock and Internal
(Pelco Frame Scan). This command is available if commands are
unlocked using the Main menu.
81-PRESET Initiates Preset Tour 1.
82-PRESET Initiates Preset Tour 2.
92-PRESET Sets the Left pan limit for an AutoScan with Limit Stops enabled.
93-PRESET Sets the Right pan limit for an AutoScan with Limit Stops enabled.
8.5
40 en | Controlling the Camera MIC612 Thermal Camera
2016.03 | 2.2 | F.01U.249.416 Operation Manual Bosch Security Systems