Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Install the MIC (standard) PSU
- MIC PSU Overview
- About the MIC Shielded Composite Cable
- Composite Cable Color-coding
- Earth Link on PCB
- Fuse Ratings
- Alarm Inputs
- Layout of MIC Power Supply Units (PSUs)
- Installation Warnings and Prerequisites
- Installation Instructions (Power Supply)
- Commissioning the Camera with Heater Option Fitted
- Simultaneous IP and Analog Video/Control ("Hybrid" Operation)
- Fit the Sunshield (MIC612)
- Getting Started
- Controlling the Camera
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Operation of the Thermal Camera
- Common User Commands
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
Alarm Setup
The Alarm Setup Menu contains alarm inputs, outputs and rules.
Notice!
The maximum number of Alarm Inputs is eight (8), available only on the Alarm and Washer
Pump Drive Card (MIC-ALM) (sold separately). This card is available for non-IR power supply
units (PSUs) only. IR models only will show Alarm Inputs 1–4 and numbers 5–12 will display
NONE. See Layout of MIC-240PSU-2 and MIC-115PSU-2, page 17 for the specific number of
alarm Inputs and Outputs per PSU.
Alarm Setup Inputs Setup
Exit... Exit...
Multi Alarm Setup 1. Alarm Input 1 N.O.
Inputs Setup... 2. Alarm Input 2 N.O.
Outputs Setup... 3. Alarm Input 3 N.O.
Rule Setup... 4. Alarm Input 4 N.O.
Restore
Defaults...
5. Alarm Input 5 N.O.
6. Alarm Input 6 N.O.
7. Alarm Input 7 N.O.
8. Alarm Input 8 N.O.
9. NONE
10. NONE
12. NONE
12. NONE
Focus / Iris: Select Type
Focus / Iris: Select Right / Left: Select Mode
9.7
MIC612 Thermal Camera On-Screen Display (OSD) Menus (Bosch Protocol) | en 55
Bosch Security Systems Operation Manual 2016.03 | 2.2 | F.01U.249.416