Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Install the MIC (standard) PSU
- MIC PSU Overview
- About the MIC Shielded Composite Cable
- Composite Cable Color-coding
- Earth Link on PCB
- Fuse Ratings
- Alarm Inputs
- Layout of MIC Power Supply Units (PSUs)
- Installation Warnings and Prerequisites
- Installation Instructions (Power Supply)
- Commissioning the Camera with Heater Option Fitted
- Simultaneous IP and Analog Video/Control ("Hybrid" Operation)
- Fit the Sunshield (MIC612)
- Getting Started
- Controlling the Camera
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Operation of the Thermal Camera
- Common User Commands
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
Diagnostics Menu
The Diagnostics menu contains a list of diagnostic tools and events. Most of these menu items
are display items only; you cannot select different values to change.
Diagnostics
Exit...
Alarm Status...
BIST...
Internal Temp: Deg F / Deg C
High Temp Events: Deg F / Deg C
Highest Temp Deg F / Deg C
Low Temp Events: Deg F / Deg C
Lowest Temp: Deg F / Deg C
Internal Humidity %
Humidity Events 0
Security Access: 0
CTFID Access: 0
Restart Events:
Power-up Events: 0
Low-Volt Events: 0
Video Loss Events: 0
Total Time On 0hr 0min
Thermal Camera Test
Pattern
On/Off
Focus / Iris: Save and Exit
Alarm Status
Enters the Alarm Status menu and displays the real time status of alarm inputs and outputs.
Alarm Inputs 1 to 8, Alarm Outputs 1 to 2 (Closed or Open)
BIST
Enters the Perform Built-in Self Tests menu. YES to start test. If confirmed, the BIST tests
start and the results are displayed. Typical results are:
Data Flash: PASS
FPGA: PASS
Bilinx: PASS
9.9
62 en | On-Screen Display (OSD) Menus (Bosch Protocol) MIC612 Thermal Camera
2016.03 | 2.2 | F.01U.249.416 Operation Manual Bosch Security Systems