Operation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety
- Unpacking
- Product Description
- Electrical Connections
- Install the MIC (standard) PSU
- MIC PSU Overview
- About the MIC Shielded Composite Cable
- Composite Cable Color-coding
- Earth Link on PCB
- Fuse Ratings
- Alarm Inputs
- Layout of MIC Power Supply Units (PSUs)
- Installation Warnings and Prerequisites
- Installation Instructions (Power Supply)
- Commissioning the Camera with Heater Option Fitted
- Simultaneous IP and Analog Video/Control ("Hybrid" Operation)
- Fit the Sunshield (MIC612)
- Getting Started
- Controlling the Camera
- On-Screen Display (OSD) Menus (Bosch Protocol)
- On-Screen Display (OSD) Menus (Pelco Protocol)
- Operation of the Thermal Camera
- Common User Commands
- Advanced Features
- Maintenance and Troubleshooting
- Technical data
- Appendices
- Back Page
– To configure a Privacy Mask, open the Main menu, select Display Setup, and then select
Privacy Mask. Alternatively, enter the keyboard command ON-87-ENTER. To setup a
privacy mask, follow the on-screen menu instructions.
– In Pelco Mode, open the Pelco Main menu, open the Bosch menu, select the Display
Setup menu, and then select Privacy Masking. To setup a privacy mask, follow the on-
screen menu instructions.
Notice!
Draw the mask 10% larger than the object to ensure that the mask completely covers the
object as the MIC612 zooms in and out.
Image Stabilization
Image Stabilization becomes increasingly important as zoom ranges are extended. The
advanced image stabilization algorithms of the MIC612 eliminate camera shake for exceptional
image clarity. Bosch achieves this clarity without reducing camera sensitivity or picture quality.
To activate image stabilization, open the Main menu, select the Camera Setup menu, and then
select Stabilization to turn on the feature.
Azimuth, Elevation, and Compass Directions
The MIC550 or the MIC612 allows a user to display the azimuth and elevation position, and
the compass heading of the camera. The MIC550 or the MIC612 displays the position data in
the lower-right corner of the image display. These readings are described as:
Azimuth The pan angle from zero to 359 degrees in one degree increments. An azimuth of
zero degrees corresponds to North.
Elevation The tilt position from zero (horizon) to –90 degrees (camera pointing straight
down) in one degree increments.
Compass The cardinal or intercardinal (N, NE, E, SE, S, SW, W, NW) heading in which the
camera is pointing.
The MIC550 or the MIC612 uses the azimuth to determine the compass direction. The
following table shows the azimuth range and its corresponding compass heading:
Azimuth
Range
Compass
Direction
21° to 65° NE (Northeast)
66° to 110° E (East)
111° to 155° SE (Southeast)
156° to 200° S (South)
201° to 245° SW (Southwest)
246° to 290° W (West)
291° to 335° NW (Northwest)
336° to 20° N (North)
13.4
13.5
80 en | Advanced Features MIC612 Thermal Camera
2016.03 | 2.2 | F.01U.249.416 Operation Manual Bosch Security Systems